4/5/2024 0 Comments H6 hole tolerance![]() These size charts do not compensate position or other GD&T location tolerances. The following ISO Tolerance Chart for bolts and holes per ISO 286. Planned joining condition between hole and shaft ISO Tolerances A tolerance assigned to a fundamental tolerance grade, e.g. Name for a combination of a fundamental deviation and a tolerance grade, e.g. Contact News Downloads PFERD Tool Manual Contact. Tolerance zones for internal dimensions: Upper limit deviation ES: µm. Note: Hole based fits should be preferred Tolerance of hole. ex: 25 H11/c11 or separated with a dash ex: 25 H11-c11 Fits are either based on the hole feature or the shaft feature. ex: 25 H11 or 25 c11 A fit is defined by the basic size followed by the tolerance of each component. Hole dimensional tolerances for regularly used ˜tting Units: µ m Standard dimension More than Not more tha A feature tolerance is defined by the basic size followed by the tolerance designation. Nominal Dimension Tolerance Zone in mm (Internal Measurements) over to H7 H8 H9 H11 H13 H14 0: 1 +0.010 0 +0.014 0 +0.025 0 +0.060 0 +0.14 0 : 1: 3 +0.010 0 +0.014 0 +0.02 H7 H6 G7 G6 F8 F7 F6 E9 E8 E7 D10 D9 D8 C10 C9 B10 ( mm ) Note: In each column, the upper figure is the upper dimensional tolerance, and the lower figure is the lower dimensional tolera Hole tolerance range class nce.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |